BPM ID Komplett | Additional equipment for BPM, LoCuM-4 and Cables
Technical Description:
In addition to the Beam Position Monitor,
FMB offers the necessary additional equipment for installation of complete BPM-units:
1. The BPM chamber
- FMB standard solution or according to customer’s specification
- material: 1.4301 or 304, option: 316LN (flanges)
2. The underframe (column)
- massive standard column, filling with sand is recommended
- insulation against variations in temperature
- special design according to space requirements is possible
3. The LoCuM-4 with cables
- for analysis of the detected photon currents
- four-channel low-current monitor and current-voltage converter
- simultaneous determination of the four independent photocurrents between 100 pA and 1mA
- controller for internal switch function – remote mode via RS232
- special double-shielded measurement cable (length about 20 m) is recommended
4. Pinhole Array
- with frame
- installation in dipole BPM
5. Appropriate bellow
- welded bellows ( about 20 membrane pairs (DN35CF) and 30 membrane pairs (DN63CF) ) for motorized stages
- hydroformed bellows for manual adjustment
6. The motorised H-V-Stage
- adjustment of the complete pre-set BPM into its accurate measurement position within the Beamline
- high precision and compactness
- with stepper motor
- encoder is recommended, but manual operation is possible (necessary mechanical limitation is installed)
Technical Data:
| H-, V-Stag e10/10 | ||
| Length over all | ≈ 354,4 mm | |
| Width over all | ≈ 195 mm | |
| Height over all | ≈ 215,5 mm … 225,5 mm | |
| Stroke Y (horz.) | 10 mm | |
| Stroke Z (vert.) | 10 mm | |
| Repeat accuracy with Encoder (option) | ± 0,001 mm | |
| Repeat accuracy with limit switch | ± 0,01 mm | |
| Threaded spindle: | ||
| -Dimension | M12x1 | |
| -Normal backlash | 0,02 mm | |
| -Pitch error | 0,003 mm…0,008 mm | |
| Stepper motor | ||
| Company | ORIENTAL | |
| Type | High-torque PK-type | |
| No. | PK268-E2,0B | |
| Holding Torque | 1,35 Nm | |
| Current per Phase | 2 A | |
| Voltage | 4,5 VDC | |
| Resitance per Phase | 2,25 Ω | |
| Angle per fullstep | 1,8° | |
| Repeat accuracy with Encoder(optional) | ± 0,001mm | |
| Step mode | Full / half / micro | |
| Connection motor | Coninvers RC-09P1N324100 | |
| Connection limit switch | Coninvers RC-12P1N324100 | |
| Encoder (option) | ||
| Company | Renishaw | |
| Type | RGH24 | |
| Resolution | 5 μm … 0,1μm | |
| Signal | TTL RS-422 | |
| Current | 120 mA (150 mA) | |
| Voltage | 5 VDC ±5% | |
| Connection | Sub-D 15 Male |
JUX_PORTFOLIO_PRO_DATE
September 9, 2022
JUX_PORTFOLIO_PRO_CATEGORY
ROOT
JUX_PORTFOLIO_PRO_TAGS
